What you need
The steps
Start the kit as soon as you can
A kit is alive. Until you start it, keep it closed in the fridge at 2–8 °C, never in the freezer.
Fresh kits give the strongest first flush.
Wash your hands and wipe the table
Most kits that go moldy are contaminated in the first five minutes. Soap and water are enough; you do not need gloves.
Open the tub and keep the lid
Take off the lid and any foil. Keep the lid clean: you will need it to soak the kit later.
Rinse the grow bag
Pour a little clean water into the bag, swirl it and pour it out. The drops left behind are the starting humidity.
Do not pour water onto the kit itself.
Stand the tub in the bag and close it
Fold the top of the bag over twice and close it with the clips, with the filter patch above the fold.
Put it somewhere warm and bright
22–26 °C, out of direct sun, away from radiators and draughts. A shelf in a living room is often perfect.
Wait for the pins
Leave the bag closed for the first days. After 5–12 days you see small white or brown knots: the pins.
Air and mist once pins appear
Once or twice a day, open the bag, fan fresh air in for a few seconds, mist the inside walls of the bag, and close it again.
Mist the bag, not the mushrooms.
Harvest before the veil tears
Pick each mushroom when the thin skin under the cap is stretched and about to tear. Hold the base, twist and pull gently.
Soak for the next flush
Fill the tub with cold clean water, put the lid on and leave it for about 12 hours in the fridge or a cool room. Drain well and go back to step 5.
Conditions to aim for
| Target | Too low | Too high | |
|---|---|---|---|
| Temperature | 22–26 °C | Slow or no pins | Above 28 °C: mold risk, weak flush |
| Humidity | Fine drops on the bag wall | Cracked caps, aborted pins | Pooling water, spots, bacteria |
| Fresh air | Air the bag once or twice a day | Long thin stems, fuzzy feet | Kit dries out |
| Light | Indirect daylight or 12 h lamp | Pale, leaning stems | Direct sun dries and heats the kit |
Five common mistakes
- Too cold. Below 20 °C a kit can sit for weeks without pinning. Use a thermometer.
- Too much water. Water pooling on the surface invites bacteria and mold. Mist the walls, not the kit.
- Never opening the bag. Mushrooms need oxygen. Without fresh air, stems grow long and thin.
- Direct sun. It overheats the bag and dries the kit.
- Leaving stumps and aborted pins. Remove them after each harvest; they rot and attract mold.
If something looks wrong
Questions people ask
Should I water my growkit?
Not directly. Keep the humidity up by misting the inside of the bag. Water goes on the kit only when you soak it between flushes.
Does the kit need light?
Yes, a little. Indirect daylight or about 12 hours of room light tells the mushrooms which way to grow. Darkness gives pale, leaning stems.
How often should I open the bag?
Not at all until pins appear, then once or twice a day for a few seconds, fanning in fresh air.
Can I grow a kit without the bag?
Not in a normal room: the air is far too dry. The bag keeps humidity around the kit while still letting some air through the filter.
Need a kit?
Fresh Mushrooms and Mycotek kits, the ones these instructions are written for.
Shop link. We may earn a commission on purchases; it never changes what we write.Written and checked by the Growkit.net editors
Last checked: 18 November 2026 · How we work
